- OPERATION PANEL IS CLOSED TS6020 REGISTRATION
- OPERATION PANEL IS CLOSED TS6020 TRIAL
- OPERATION PANEL IS CLOSED TS6020 WINDOWS
OPERATION PANEL IS CLOSED TS6020 WINDOWS
When printing, select the size and type of the loaded paper on the print settings screen of the operation panel or printer driver.įor instructions on specifying the paper feed source when printing from a Windows PC, tap here.įor instructions on specifying the paper feed source when printing from a Mac, tap here. If the operation panel is closed, the printer does not start printing.
Open the operation panel (I), pull out the paper output tray (J) and paper output support (K), and open the output tray extension (L).īe sure to open the operation panel before printing. Select the size and type of the loaded paper in the rear tray at Page size and Type, and then select Register.
OPERATION PANEL IS CLOSED TS6020 REGISTRATION
Be sure to close the feed slot cover.Īfter closing the feed slot cover, the paper information registration screen for the rear tray is displayed on the touch screen. If the feed slot cover is open, paper cannot be fed. Loading paper in the landscape orientation (F) can cause paper jams.ĭo not load sheets of paper higher than the load limit mark (G). The paper may not be fed properly.Īlways load the paper in the portrait orientation (E). Using the hardware provided, mount the back of the control panel in a location close enough to the water heater so that both the actuator and sensor wiring can be connected to the control panel. You will find the switch on the control panel (or on the area above the door). Control Panel and Wiring Press the tabs on the side of the control panel and pull apart to separate the front panel from the back panel. Other models have a light switch for manually operating the oven light. On some models, the oven light will turn on automatically when the oven door is opened. Slide the paper guides (D) to align them with both sides of the paper stack.ĭo not slide the paper guides too hard against the paper. Press the Open/Close Command button and note gate operation. Ranges and wall ovens have an interior light. Slide the paper guides to open them, and load the paper in the center of the rear tray with the print side facing up.
To load the paper, first open the rear tray cover (A) and then pull up the paper support (B). If the paper is curled, hold the curled corners and gently bend them in the opposite direction until the paper becomes completely flat. Loading paper without aligning the edges may cause paper jams. You can use general copy paper or Canon Red Label Superior WOP111/Canon Océ Office Colour Paper SAT213.įor the page size and paper weight you can use for this printer, see supported media types.Īlign the edges of paper neatly before loading. We recommend Canon genuine photo paper for printing photos.įor details on the Canon genuine paper, see supported media types. Elevated Boardwalk portion of the trail is open for day and nightime use. SkyTrail / Tulip Tower is open for daytime use only & will close 30 minutes after sunset. Check the schedule and hours of operation of the Gatlinburg SkyLift and SkyBridge.
OPERATION PANEL IS CLOSED TS6020 TRIAL
If you cut plain paper into small size such as 4" x 6" (10 x 15 cm) or 5" x 7" (13 x 18 cm) to perform trial print, it can cause paper jams. Check the schedule and hours of operation of the Gatlinburg SkyLift and SkyBridge. You can also load envelopes in the rear tray.
0 kommentar(er)
